The Collectible GMC Motor Home
In the 1970's, General Motors entered the RV market. Drawing on
the exuberance of the times, the company set out to create the
ultimate American Motor home. Their aim was to produce a top-of
the-line vehicle with cutting-edge design and construction, not
just another competitor in the already crowded vacation vehicle
market. The common design in this era was a boxy, ungainly and
top-heavy unit on a truck chassis. The GMC vehicle was intended
to be a completely new design in every way. Design work began in
1970, with the market introduction planned for 1973. "Doesn't
look like a box or ride like a truck" was the GMC ad slogan.
The new vehicle would be unusual for this era in several ways.
First of all, it was to have a front wheel drive, a rare concept
in cars of that day and unheard-of in mobile homes. The drive
train and suspension were taken from the design of the
Oldsmobile Toronado. The 265 horsepower 455 cubic inch
Oldsmobile engine was attached to a Turbohydramatic 425
transmission with torsion bar suspension. The rear suspension
was a product of GM's bus design, using dual swing arms, one
leading and one trailing, with a single air spring on each side.
Instead of a auto body steel, the body was to be made of
lightweight aluminum and molded fiberglass-reinforced plastic
such as was used in the Chevrolet Corvette.
The front wheel drive and independent swing arm rear suspension
brought great improvement to the standard motor home design. The
lack of drive shafts and axles underneath the coach allowed a
very low floor height, leading in turn to a low overall vehicle
height and lower center of gravity. Aside from easier entry and
exit, this reduced rollover risk and wind resistance and made
the vehicle much safer and easier to operate for buyers
accustomed only to car driving. A six-wheel braking system, with
disc brakes on the front and drum brakes on all four rear
wheels, further enhanced drivability.
Previous motor home design focused mainly on the use of the
vehicle as a temporary home once it had reached its destination,
an extended stay in a mobile home park or a camping spot. Ease
of getting to the destination was of secondary concern, and
cumbersome handling on the road was taken for granted. GMC made
a special point of targeting this feature for improvement by
adding visibility from the driver's seat with a panoramic
expanse of glass.
The motor home was featured in 23 foot and 26 foot lengths,
fairly small even for this era. Nowadays, much larger models are
common. The motor home's interior design was compact, with no
permanent sleeping areas in the original design. All beds were
converted from seating areas when required.
Hot water was provided by water heaters using engine coolant
loops, which produced water so hot it could actually present a
scalding hazard since coolant temperatures usually exceed 200
degrees Fahrenheit. The refrigerator was powered by a standard
automotive battery, adequate only for overnight use before
recharging.
The prototype was first displayed in May 1972 at the Transpro
'72 trade show in Washington, D.C. Production started in 1973
with two models, Model 230 and Model 260, 23 and 26 feet long
respectively. They were sold with a finished interior for the
public as well as unfinished to other RV manufacturers such as
Avion and Coachman, who then provided their own interiors before
reselling to consumers. 30 different floor plans were available,
and models were priced from $35,000 to $40,000.
The GMC vehicle changed slightly over time, the most notable
alteration coming in 1977 when the 455 cubic inch engine was
replaced by a 403 cubic inch model in response to the energy
crisis. This decade caused hardship for all RV manufacturers as
the increased price of fuel pushed large gas guzzling vehicles
out of the market. The GMC motor home had never sold at high
volumes, and the company decided that the RV production
facilities could be more profitably used to make light trucks.
After the manufacture of 12,921 vehicles, production of motor
homes was discontinued after the 1978 model year.
Almost immediately after production ceased, GMC motor homes
became collectors' items, with owners' associations being
established to provide parts and service for these vehicles.
Small manufacturers and garages developed a cottage industry
servicing them. In 1992, as General Motors prepared to scrap all
remaining tools and parts, Cinnabar Engineering purchased all
the motor home manufacturing supplies and negotiated a deal to
continue to provide parts for the discontinued vehicles. In
1992, a monthly magazine called GMC Motor home Marketplace was
introduced, and in 1994 Cinnabar started publishing a quarterly
newsletter called GMC Motor home News.
The vehicle's futuristic design has even found a place in pop
culture: Mattel Toys created die-cast versions of the GMC motor
home for its Hot Wheels line. More than 50 different GMC Hot
Wheels are available, and in 1977, Mattel released three toy GMC
versions in a Barbie Doll Star Traveler promotion.
In an amazing example of customer loyalty and product
durability, more than 8,000 units are still registered by
owners. An internet search of "GMC Motor home" produces 771,000
results, as sites advertise motor home parts, engines and
upgrades as well as classic car rallies for owners. Used GMC
motor homes sell for $10,000 to $15,000 depending on the
condition of the vehicle.