Materials Needed:

3/8" X 4' X 8' sheets of plywood
8' 2x4's
electric, handheld or bench saws
handsaw
hammer & nails
electric sander/sandpaper
drafting compass
string & chalk
garden hose
sawhorses
nail punch
ink pen
wood screws
3/8" PVC pipe
pushpin

1) Decide on the type of ramp(s) you want to build, sketch out the design and dimensions on paper.

2) Acquire the materials required, and as much wood as you can get your hands on

3) Find a work space to use (garage, backyard, etc.) and lay out your supplies. If you're planning to build a fairly large structure (permanent) try to build it on site.

4) For ramps with curved transitions, you will need to use the string-and-compass method*.

5) Once you've drawn and cut your templates, next comes the bracing.

6) Once you've done the framework, you'll most likely need to prep the top piece(s) of the plywood (which must bend to fit the transition without breaking). Do this by propping up the sheet(s)--already cut to size--at a sloping angle and soak with a hose at low pressure for an hour or so.

As the wood becomes soaked, apply an increasing amount of weight to the center of the board(s)--using bricks or something similar--until the wood attains the desired curve.

Now nail the wood onto the framework's 2x4's If your ramp is to have coping, make sure to leave enough space for it to fit snugly. Always go WITH the grain of the wood while bending and apply the ply!

For a smoother transition, sand the bottom edge of the top sheet at an angle flush with the ground. Check for jagged splinters. Sand or paint if desired. Paint will make your ramp faster! Duct tape, airplane or electrical tape or aluminum strips may be added to smooth the transition's bottom edge.

* String and Compass Method

Figure how much transition curve you want (in feet & inches) and how much