Building a BMX Bunny Hop Trainer.

Learning to get enough height to start grinding and stalling can be a real challenge for the beginning BMX biker. Here is something that can be built and used to get the heights needed. The best part about it that it is cheap and easy to build. Materials can found at your local lumber/hardware store. The materials needed are as follows; 2-2"x4"x3'board 1-1/2"x8' piece of hard plastic water pipe. 20-2" finish nails. 1-3/4"x1'x4' plywood 4-3"deck screws With the materials assemble as the diagram illustrates. "You can see the detailed picture at www.evilbmx.biz under articles page". The 3" deck screws come up from the bottom of the plywood into the 2"x4"x3' boards. The finishing nails are nailed into the board about